铜雕,铜雕厂,铸铜雕塑厂,铜雕厂家

 如何保养铜雕有几大技巧?

How to maintain the bronze sculpture?

现在大量的生产铜雕，但是广大的铜雕收藏爱好者不知道怎么收藏铜雕，以至于大量的铜雕色泽黯淡无光，时间久了也就没什么收藏价值了，现在铜雕厂给您分享保养铜雕工艺品要注意以下以点：

Now a large number of copper carvings are produced, but the vast number of copper carving collectors do not know how to collect copper carvings, so that a large number of copper carvings have dim color and no collection value for a long time. Now the copper carving factory to share with you the maintenance of copper carving crafts should pay attention to the following points:

1、铜雕工艺品必须放在干燥的环境里来保护，保持干燥，没有尘埃和空气污染物；温度在18℃-24℃，相对湿度在40%-50%。

1. Copper carving crafts must be protected in a dry environment, keeping dry, free of dust and air pollutants; the temperature is between 18 and 24 degrees Celsius, and the relative humidity is between 40% and 50%.

2、必须预防接触铜雕工艺品产生的有害化学作用物质，如酸类、油脂、氯化物等。紫铜浮雕最应该注意了。

2. It is necessary to prevent harmful chemical substances, such as acids, greases, chlorides, etc., from being exposed to copper carving crafts. Copper relief should be paid more attention to.

3、铜雕工艺品摆放时间过长之后，依据摆放的环境或多或少会出现一些暗哑的现象，这个时候可以用棉丝质的细布轻轻来回擦拭，可达到抛光的效果，从而让表面的保护蜡层重新焕发光彩。尤其是铸铜雕塑的维护，更应该是这样的。

3. After the bronze carving crafts have been placed for too long, some dumb phenomena will appear more or less according to the environment. At this time, it can be gently wiped back and forth with cotton silk fine cloth, which can achieve the polishing effect, so that the protective wax layer on the surface will glow again. Especially the maintenance of cast copper sculpture should be like this.

4、对于青铜佛像工艺品上的尘埃，先用冷风电吹风吹一下，然后用麦杆刷清洁，最后用软毛刷收尾,千万不要用金属抛光剂、水、其他任何溶剂，对于缝隙，铜雕厂可以用口水把棉花球弄湿再擦，沿着裂缝从头擦到尾，以免遗漏。

4. For the dust on bronze Buddha statue crafts, first blow it with cold wind and electric drier, then clean it with straw brush, and finally finish it with soft brush. Never use metal polishing agent, water or any other solvent. For cracks, the bronze sculpture factory can moisten the cotton ball with saliva and wipe it from beginning to end, so as not to miss it. 。